A course to allow students to learn basic electronics and C++ language. From using basic programming to light a LED, to creating an input signal to control LEDs. We will be offering further courses to expand on this knowledge. In-house volunteers who are programming specialist and electronic tutors who will deliver this course for up to 10 students.

Introduction to PC, Arduino board, C++, Electronic Parts i.e., LED, Resistors & PC to Arduino Interfacing and uploading code to the Arduino controller board using Sketch (software).

First Circuit (LED Blink) & Two LEDs Blink – Learning the program and electronic parts to enable these projects.

Learned previously how to control 1 or 2 LEDs through Sketch on the control board and learned some basic knowledge of programming. Now we control 10 LEDs and learn how to simplify the code.

We have used Sketch to control up to 10 LEDs on the control board to blink and learned some basic knowledge of programming. Now, we will make LED emit different brightness of light

We have used the control board to output signals to make 10 LEDs flash and make one LED emit different brightness. Now, we learn how to get an input signal.

During these two hours, we will be allowing our students to demonstrate and show their work to their parents or guardians, followed by Q&A fill in sheets and a little presentation to remember their time with us. We will also advise them on the next steps if they want to get more involved with programming and electronics.